Jan 23, 2013 · My research brought me to a solution, using DD-WRT. According to the DD-WRT Wiki, “DD-WRT is a third party developed firmware released under the terms of the GPL for many ieee802.11a/b/g/h/n wireless routers based on a Broadcom or Atheros chip reference design.”

Apr 19, 2015 · Set wireless mode from “AP” (default) to “Client Bridge”. Client bridge mode is like repeater bridge mode, but doesn’t extend the wireless signal of the main router. I say to set this up first because it’s simpler than repeater bridge mode, and thus it’s easier to fix when something goes wrong. Jan 19, 2007 · Because wireless repeater mode is a new feature, and technically still in beta, using it puts you on the leading edge of DD-WRT technology. This also means you may run into problems with the limitations of wireless repeater mode, and there are some. At the time of this writing, wireless repeater mode does not yet function in bridged mode. Jan 23, 2013 · My research brought me to a solution, using DD-WRT. According to the DD-WRT Wiki, “DD-WRT is a third party developed firmware released under the terms of the GPL for many ieee802.11a/b/g/h/n wireless routers based on a Broadcom or Atheros chip reference design.” In addition to ‘client’ and ‘client bridge’ mode bridge means the connection isn’t NAT’d DD-WRT now has ‘repeater’ and ‘repeater bridge’ mode. The router will attach to the access point of your choice and then rebroadcast the signal as the SSID of your choosing. You do this by setting up a virtual wireless interface.

New in DD-WRT v24 is Repeater Bridge mode. This extends your primary LAN via secondary router (bridge router) and also allows wireless clients to connect to your secondary router. This extends the range of your wireless network while simultaneously allowing wired clients to connect to your secondary router.

In configuring the DD-WRT router to act as a wireless repeater, you must configure two connections. The first, is the wireless link between the remote AP and the DD-WRT router. This is configured on the DD-WRT routers physical interface so that the DD-WRT router can join the remote AP's network as a client, just like a laptop would. [FIXED] Can't seem to get "Universal Wireless Repeater& May 31, 2010

The limitation with standard bridging is that it only allows wired clients to connect to your secondary router.Wireless clients cannot connect to your secondary router configured as a standard bridge.. New in DD-WRT v24 is Repeater Bridge mode. This extends your primary LAN via secondary router (bridge router) and also allows wireless clients to connect to your secondary router.

The funny poles are actually DD-WRT routers and one is configured as the primary. If your modem has wireless and a switch you can just leave that primary router out, since it is just configured as a standard access point. The secondary is actually a DD-WRT router in repeater bridge mode. #2253 (Repeater mode broken in newer builds of K26 only I'm using dd-wrt.v24-16773_NEWD-2_K2.6_mega Eko on a asus rt-n16 and repeater and vssid works, this is the only build I have found to work. make sure you set the "Wireless Network Mode" to match that of what you are repeating, and if you are using MAC clone make sure to set the security mode of the vssid to match the repeated AP.